It is located in the same place as a 350ci Chevrolet engine. The 4.3, also known as the "Three-Quarter Three-Fifty" (because it is just a 350ci block with 2 cylinders shaved off), generally has it's cam sensor underneath the driver's side exhaust manifold. Depending on the year, you may find a knock sensor there instead, and the cam sensor will be between your firewall and engine block.
Not sure what year 4.3 you have but if it has a distributor, that would be the cam sensor.
The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.
The camshaft position sensor on a 4.6 liter engine is positioned on the side of the motor on the front of the cylinder head. A 4.6 liter engine has a camshaft position sensor on each cylinder head.
Hi The CAMshaft position sensor on the v-8 4.7 liter engine is on the front right side (passenger) of the engine bank. The CRANKshaft sensor is behine the stater motor on the passenger side
The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.
In the distributor
It would help if you stated what type of vehicle it is. There are several 2.7 engines in different vehicle types.
The camshaft position sensor is inside the distributor.
The Cam sensor is the "pick up plate" in the distributor, under the cap.
top rear of engine
Yes, the cam sensor is inside the distributor.
Inside distributor under rotor.
The camshaft position sensor is mounted on the front of the 5.9l engine. It is at the top of the timing cover, on the back of the flange.
where is the camshaft sensor on a 2006 dodge ram 5.7 litre
It is under the front of the passenger side cylinder head.
it is in the distributor
i think u mean crank sensor and that would be by the dampener or balancer in the front of engine (near crankshaft)
2000 SEwhat year do you have, and do you have a 3.0 liter 12 valve engine, or a 3.0 liter 24 valve DOHC engine?12 valve
On the Ford 4.0 liter EFI , V6 engine : From what I have read : The camshaft position sensor is on the top of the engine , near the centerline , at the rear of the engine near the firewall . You cannot see it unless the upper intake manifold is removed
it is part of the egr valve
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
I'm not a mechanic / technician but from what I have read : The camshaft position sensor on top of the camshaft position synchronizer on the Ford 4.0 liter EFI , V6 engine , is on top of the engine , near the center line , at the back of the engine near the firewall * apparently you can't see it until the upper intake manifold is removed
It is under the front outside of the passenger side cylinder head.
It is behind the starter.
I'm not a mechanic / technician but the Ford 3.8 liter V6 engine is an Over Head Valve / pushrod design engine that has ( 1 camshaft ) so I assume there would only be ( 1 camshaft position sensor )
The camshaft position sensor is a part of the distributer. There are 2 electrical plugs going to it, 1 is for the coil,the other is for the Camshaft sensor.