It's going to be off the valve cover(s) one or the other. Plugged right into it.
PCV Valve is located near front of hood on the engine block between the fuel injectors.
Remove the vacuum hose from your 1989 Oldsmobile 3.8 liter engine PCV valve. Remove the retaining bolts from the valve. Reverse the process to install the new PCV valve.
The PCV valve is located in the rocker cover (valve cover) Once you locate it pull up on the hose that is connected to it. Remove the PCV valve and put new one in. Reinstall in rocker cover.
Some of the 2000 models have a PCV valve on the back of the valve cover. The other models do not have a PCV valve, but use an oil/air separator instead.
The pcv valve on a 1989 Camaro is located in the top of the valve cover. It plugs into a rubber grommet and is easily replaceable.
It is in the valve cover.
Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.
UNDER HOOD, CENTER, UPPER ENGINE AREA, TOP OF ENGINE, MOUNTED IN PASSENGER SIDE OF INTAKE MANIFOLD
THERE IS NOT ONE.
When you shake the PCV valve it should rattle. If it does not rattle then it is probably stuck and should be replaced.
Generally you will find a PCV valve somewhere on one of the valve covers, with a hose the connects to it.
4.0? Those actually dont have PCV valves, it is the rubber grommet on top of the valve cover
In the right rear of the valve cover.
on the 3.4L V6 it is located on the front valve cover, just to the right of the oil filler cap. there is a hose with a 90 degree boot on it. remove that and pull out the PCV valve.
The PCV valve is on top of the rear valve cover. The air intake plenum extends over the top of the valve making it difficult to see.
The answer is Yes.
PCV IS ON LEFT SIDE VALVE COVER TOWARDS THE FRONT IF YOUR FACING THE MOTOR
remove cowling it is on the passenger side valve cover
its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.
front side of plastic intake manifold
Pull upward on the hose that the PCV valve is in. The PCV valve will pull out of the hose. The PCV valve is located in the valve cover.
Disconnect the PCV valve tube from the PCV valve.Disconnect the PCV valve electrical connector if it has one.Turn the PCV valve counterclockwise to remove from the valve cover.To install, reverse the removal procedure.
Look on the front valve cover and it is to the right of the oil fill cap. There will be a black hose going to it that makes a 90 degree angle. Pull that off and then pull the PCV out.
black with siver capsule