Where is the blower motor resistor on a 2002 Oldsmobile Intrigue?
I have a 98 olds intrigue and the blower motor resistor is located under the glove box behind the blower....
If heater fan is working but nothing coming out would the problem be blower resistor or switch for 1999 Oldsmobile intrigue?
You have a bad blower resistor. it is located directly behind the blower motor on the passenger side of the vehicle. You must first disconnect blower motor from bad resistor. Lower and remove blower. It won't be easy but remove the screws holding the resistor, disconnect the resistor and remove it. Cost is approximately $40 for a new one.
Fig 15 Blower Motor Resistor NOTE: The blower motor resistor is located on the lower right side of the heater housing. REMOVAL # Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
Disconnect the battery negative cable. !!!Power is still on when ignition switch off!!! I have Olds Intrigue 2000. Blower control resistor (Controller) located behind the blower motor. Very close to the firewall, and it is a pain in the neck to get there. Using 5.5 mm. socket remove the blower first. (3 screws are holding the blower) Using the same socket (5.5 mm) remove one visible screw which holds the resistor. You will have to…
To test the blower motor resistor, unplug the resistor connector. Each blower motor switch input terminal on the resistor must have continuity to the resistor output terminal, which is connected to the circuit going to the blower motor. If the blower motor resistor continuity does not check OK, replace the faulty resistor.You need a multimeter to test the resistor block and there should be continuity between all terminals.
How can you figure out which to replace the blower motor or blower motor resistor on a 1994 Nissan altima?
Why does the blower motor not work on the first and second notch on a 99 intrigue and it won't blow very hard on the third forth or fifth notch?
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch . Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor. Remove the two screws that secure the blower motor resistor block to the HVAC housing. Remove the resistor block from the HVAC housing............
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.