There isn't a "cam sensor", because the car has a distributor. So the ignition module attached to the side of the distributor connects to a hall effect sensor that is in the distributor under the circular slotted vanes attached to the distributor shaft. There is a four pointed star-looking piece in the distributor that should be firmly fixed to the shaft. If that piece is loose, that may be your problem (you'll need to buy a new dist). The sensor itself rarely fails.
on the right side of the block just above the trany The sensor is located just above the manfol.
The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.
It is located in the front of the engine, above the oil filter, next to the starter. Your going to have to remove the starter for easier access to the sensor.
The 1999 4.7 liter engine temperature sensor is located just above the thermostat housing. The sensor will be on the front of the engine.
Where is located
The vehicle speed sensor (vss) should be located on the driver side on the front of the transmission close to the axle. Their should be an ear protruding out from the transmission, and the sensor will be to the right of it.
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
Some place in the world i think
The coolant temp sensor is located next the the thermostat housing.
on the front of the engine, behind the power steering pump, under the lower intake manifold. good luck.
Where is crankshaft position sensor located on a 1996 Toyota corolla 1.6 liter?Read more: Where_is_crankshaft_position_sensor_located_on_a_1995_Toyota_corolla_1.6_liter#ixzz1nWxVCKMW
right above the oil filter