Located on the top front left (drivers side) valve cover. Vehicle production date is 04/03
according to my Haynes repair manual the camshaft position sensor for the 4.0 L OHV engine is located at the rear of the engine block, on the top of the engine block
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
The camshaft position sensor on a 4.3L engine would be in the distributor.
In a 1996 Ford Explorer , 4.0 liter EFI , V6 engine : From what I have read the camshaft position sensor is located on the top of the engine , near the centerline , at the rear of the engine near the firewall . Apparently you can't see it until the upper intake manifold is removed
The camshaft position sensor on the 1999 4.0 L OHV engine is located at the rear of the engine block on the top of the engine where the distributor was installed on earlier versions of this engine. (according to my Haynes repair manual)
The camshaft position sensor is most likely located on the cylinder head of the engine. The location could vary depending on the manufacturer.
I'm not a mechanic / technician but I believe the camshaft position sensor on a 1999 Ford Explorer XLT , with the 4.0 liter SOHC , V6 engine is ( on the drivers side valve cover , near the engine oil fill cap )
does any one know where the camshaft position sensor is located on a 1996 ford explorer 4.0. Thanks Gil N.Y.C right behind the motor .its impossiable to get your hands in it,you might have to pul the motor to get to it..
Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine
The camshaft position sensor on your 2002 automobile is located on the front of the camshaft. You will need to remove the front engine cover to access the sensor.
The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.
The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.