hey Zim==I think it is in the dist on this engine. GoodluckJoe
If your standing in front of the car its on the front of the moter where the trany and moter meet behind the exaust its a pain really tight space, best to go from under the car i have a lift and i still had a tough time.
On the 4.0L SOHC engine (VIN E), the Camshaft Position (CMP) sensor is a variable reluctance sensor, which is triggered by the high-point mark on the left-hand camshaft. It is mounted to the valve cover. The 4.0L and 5.0L engines use a separate CMP sensor mounted to the oil pump drive. The drive assembly is located toward the rear of the engine on the 4.0L, and towards the front on the 5.0L engine. 4.0L SOHC Engine (VIN E) Disconnect the negative battery cable. Disconnect the engine control sensor wiring from the camshaft position sensor. Remove the sensor retaining screw and the sensor from the left-hand valve cover. To install: Make sure the camshaft position sensor mounting surface is clean and the O-ring is positioned correctly. Position the sensor, then install the retaining screw and tighten it to 71-106 inch lbs. (8-12 Nm). WARNING Do not overtighten the screw; you may damage the sensor if the retaining screw is overtightened Engage the wiring harness connector to the CMP sensor. Connect the negative battery cable.
You need about 2-3 feet in socket extensions and a swivel socket head. It bolts into the top driver's side of the bell housing. Just 2 bolts hold it on and if I remember correctly they are 12mm.
camshaft sensor is on the front of the engine block ,just above the harmonic balancer. it is easiest to reach from underneath the vehicle.
camshaft positioning sencer is located on the front side of the right head as your facing the front of your car it is very easy to get to one bolt holds it on its rite below the valve cover
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
where is the O2 sensor on a 2002 chevy trailblazer
Was that the only code that caused you to replace it? Do you have it close enough to sense again.
2
Neon door sensor is located in the door latch. The closed door creates a complete circuit through a ground wire. The completed circuit shuts the light off.
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
The camshaft position sensor on your 2002 automobile is located on the front of the camshaft. You will need to remove the front engine cover to access the sensor.
wher is the camshaft sensor for escort2002
The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.
unplug wire remove 2 7/32 bolts remove sensor
The camshaft position sensor on a 2002 Mitsubishi Gallant is located behind the rear camshaft bearing. It constantly updates the vehicle' computer about the status of the camshaft.
Where is camshaft sensor on 2002 Lincoln ls
on top
The camshaft sensor is located inside the distributor.
The MAP sensor on a Trailblazer is the Manifold Air Positioning sensor. It is located on the top of the engine.
It still has a distributor.