Best Answer

The check engine light is triggered by the Engine Control Module (ECM). The ECM receives information from many sensors and determines when to illuminate the check engine light.

User Avatar

Wiki User

โˆ™ 2011-08-01 21:07:15
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the check engine sensor on a 85 chevy S10 blazer?
Write your answer...
Still have questions?
magnify glass
Related questions

How do you reset check engine light for the 2009 Chevy trail blazer?

How do you reset check engine light for the 2009 Chevy trail blazer?

Where is knock sensor Chevy Blazer 04?

Check the owner's manual.

Will a bad heat sensor cause your Chevy s10 blazer not to start?

A bad engine temp sensor can do that.

Where is the cam sensor located on a 2002 Chevy blazer?

Assuming that it has a 4.3L engine, it would be the distributor.

Will a faulty oxygen sensor cause your engine light to come on in a 1996 Chevy blazer?


Engine running lean 95 Chevy blazer?

Check for vacuum leaks.

Locating crankshaft sensor for 1999 Chevy blazer?

The crankshaft sensor on a 1999 Chevy Blazer is located on the bottom of the engine, near the oil filter. It connects to the vehicle's computer and constantly updates it on the crankshaft's position.

Location of the MAP sensor on a 1991 Chevy Blazer?

where the map sensor on 98 blazer?

Were do you ground the temperature sensor for a 93 s10 blazer 4.3 vortech?

The 1993 Chevy S 10 Blazer 4.3 liter engine temperature sensor can be grounded to the engine block. You can use the temperature sensor retaining bolts to ground the temperature sensor.

Where is the temperature Sensor on a 1995 Chevy S10 Blazer?

The temp sensor for the ECM (engine control module) is next to the thermostat housing.

1994 Chevy s-10 blazer runs very ruff and dumps fuel out of the exhaust?

Check for codes in OBD. I have seen a bad engine coolant sensor do that.

Will knock sensor turn on check engine light on 1997 Chevy s10 blazer?

YES, It sure can if that is the problem. FIRST you need to have the engine scanned with a OBDII engine scanner to see what CODES the computer has stored.

People also asked