master cylinder is the one where the brake fluid is stored and its in the top left hand side of your car right in front of the steering wheel in the engine conpartment
how do you bleed the clutch master cylinder in a 2005 mazda 3
Yes there is a hydraulic clutch on the miata. Just to the outside of the firewall, near the brake master cylinder is the clutch master cylinder and resevoir.
the clutch and the brakes share the same master cylinder on my 1991 protege dx 1.8 sohc
First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.
No fluid in the master cylinder
no it is hydraulic.dont know what your problem is but check clutch master cylinder and slave cylinder operation,if ok may just be a bad clutch
Check for bad clutch master cylinder or slave cylinder.
there is no clutch cable. it has a hydraulic clutch. there will be a clutch master cylinder on the firewall near the brake M/C. a hydraulic hose will connect that to the clutch slave cylinder on or near the tranny. the slave cylinder pushes on a fork (lever) that disengages the clutch.
Clutch master cylinder might be blown out. this is located in the engine bay, the top right.
its in the engine bay next to your brake master cylinder its the tube like cylinder that says dot3 fluid
The clutch hydraulic fluid reservoir for a Mazda 121 is located next to the brake booster and brake master cylinder. The reservoir is small and round and is close to the driver side fender.
the piston in your clutch master cylinder is stuck in the cylinder body. you need to remove, hone out, rebuild or buy (best) a new one. on line about $50.