Chevy Lumina
Buick Rendezvous
Ford Ranger XL

Where is the coolant sensor on a 1991 Chevy Lumina?

789

Top Answer
User Avatar
Wiki User
2008-07-01 16:22:23
2008-07-01 16:22:23

Here's a link to a schematic and instructions on replacing the coolant sensor (from the Auto Zone website) http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280067b92 Good luck!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how to add coolant to 1991 lumina?

User Avatar

Should be by the alternator in the back

User Avatar

problem with the coolant sensor check the connection on the sensor reset your OBD I code if that don't work replace the coolant sensor

User Avatar

how can i change the turn singal on a 1990 Chevy lumina

User Avatar

Probably not, but it will certainly cost in fuel, performance and excessive emissions.

User Avatar

The 1991 Chevy Lumina is fuel injected and has no carburetor.

User Avatar

The turn signal switch location on a 1991 Chevy Lumina is behind the steering column. You will need to use a socket set to get to the switch.

User Avatar

code 15 coolant temp sensor low temp indicated change cts sensor or test with multi meter

User Avatar

where is the fuel pressure regulator on1991 lumina 3.1 /

User Avatar

temp light is on a 1991 Chevy lumina car not hot...

User Avatar

The coolant gauge temp sensor is a one wire sensor located on the right rear of the engine block.

User Avatar

The speed sensor on a 90 lumina 3.1 should be on the drivers side top of the tranny, below the steering rod. Sould be a screw in sensor with wires attached.

User Avatar

why does my 1991 Chevy lumina that when going up a hill or when it reaches approximatly 65 mph starts hestitating, when cars get older they do that.

User Avatar

The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.

User Avatar

Listed on the driver's door post and in your owner's manual.

User Avatar

The 1990 has a chain. The 1991 has a belt.

User Avatar

1991 probably doesn't have a crank sensor, it probably has a reference in the distributor.

User Avatar

where the map sensor on 98 blazer?

User Avatar

it is under the dash not visable from the seat next to the kick panel


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.