in the front on side of the harmonic balancer
The crank positioning sensor is located on the opposite side of the block as the timing belt.
2.0ltr its in distributer
where is the crank sensor located on a ford e250 1999
where is the crank positioning sensor on a 1996 newyorker van
The only engine speed sensor is the pick up plate in the distributor.
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
the cam positioning sensor is located on the front of the engine block, above the harmonic balance pulley. easiest to get at this from underneath the vehicle,and to change the snsor, nothing else needs to be removed to get at it.
The crank sensor is located on the bottom of the timing cover under the right hand side of the water pump by the crankshaft pulley.
It is in the oil pan. Nissan has had a recall to reprogram the sensor. They may have to replace the sensor for free. It cost about $600 for repair.
The crank shaft positioning sensor should be located at the front of the engine just below and to the left of the harmonic balancer. On the timing cover.
The crank shaft positioning sensor is behind the starter. A real bear to get to.
It is bolted in the passenger side of the timing cover, Behind the harmonic balancer.