Just above the oil filter on the engine block.
the 1995 and before 3.0L's only have the sensor in the distributor. No crank sensor.
The crank sensor is located on the passenger side of the bell housing near the valve cover. It is held in place by two Allen head cap screws.
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
The crank positioning sensor is located on the opposite side of the block as the timing belt.
A 1995 blazer does not have a crank sensor. SORRY
On the bellhousing
No, the computer needs that sensor to know crank timing.
Does your vehicle have the LT1? if so there is no crank sensor.. there is an optic sensor in the distributor that controls all..
This could be a problem with your cam sensor, or crank sensor.
No, just the distributor pick up plate (cam sensor)
It is located in the transmission.
inside the distributor inside the distributor
Behind oil filter
in a toilet
The crankshaft position sensor for the 1995 Monte Carlo is located on the front of the engine. It is just to the right of where the crankshaft comes out of the engine.
A crank sensor was not USED on a 1995 model.
A 1995 Ram does not have a mass airflow sensor.
The speed sensor for a 1995 Neon is on the side of the transmission. It is mounted behind the vehicles exhaust.
Crankshaft Sensor Location 1995 aerostar 3.0 l videos
I don't believe that the altima had a crankshaft position sensor until 1995.
on the right front of the transmission bell housing about 3 o'clock. If you are looking at the engine it will be on the left. There is 1 10mm bolt holding it down.
its located inside the distributor itself
To test a 1995 Cavalier crank sensor you would need to get a mechanic's computer. They can put a sensor/fuse tester on it and see if it is working properly.
In the exhaust pipe close to the manifold.
2002 ford crown Victoria how to repair crank sensor?