answersLogoWhite

0


Best Answer

The Crank angle sensor should be on the flywheel aka harmonic balancer aka crankshaft at the bottom of the engine. The largest wheel for your accessory belts. There is a wire that conects to it

User Avatar

Wiki User

โˆ™ 2005-12-07 17:23:04
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the crank sensor unit located on a 1996 ford Probe GT?
Write your answer...
Submit
Related questions

Where is the camshaft position sensor and the crankshaft sensor located on a 1996 olds bravada?

It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley


Where is 1996 Oldsmobile Cutlass Supreme Position Sensor Location?

where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine


Where is crankshaft position sensor located in a 1996 accord?

by what i understand its located between the crank pully and block.


Where is the crank sensor located on a 1996 Concorde?

the crank sensor is located in the transmission bellhousing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft.


Where is the crank sensor located on a 1996 Dodge Ram van 3.9 b2500 and how do you install a new one?

The crank sensor is located on the bell housing of the transmission on passenger side. You will need an Allen wrench.


Is there a crank sensor on a 93 suburban?

NO. A crank sensor are cam sensor was not introduced until the year 1996.


Where is the crank sensor on a 1994 Chrysler 3.3?

where is the crank positioning sensor on a 1996 newyorker van


Where is the crank sensor on a 1996 Jeep?

The crank sensor is mounted on the top of the transmission bell housing.


Where is crank sensor on 1996 Ford F-250 5.8?

What position is the crank sensor on a f250 ford pickup


What would cause tachometer to quit on 1996 dodge ram diesel?

Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.


Where is the crank shaft sensor located on a 1993 C-1500 pickup?

There is not 1 on that year. They were NOT used untill 1996


Where is crank position sensor located on 1996 Tahoe 5.7?

It is on the passenger side of the timing cover that is on the front of the engine.


Where is the crank sensor on a 1996 Plymouth Voyager?

It is located on the lower bottom left side of the engine near the crankshaft.


Where is the crank sensor located in the 1996 Chrysler LHS?

the crank sensor is located in the transmission bellhousing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft. one 10 mm bolt holds the sensor in place, this is on the 3.5 liter engine,


Where are the camshaft and crankshaft sensor located in a 1996 Yukon?

depends on the engine but it is usually on the top of the bellhousing of the tranny. the crank sensor gets a pickup signal from the flywheel.


Why doesn't your 1996 Ram 1500 5.2 have no spark and no fuel and just cranks but no fire?

either crank sensor or cam sensor. but more then likely its the cam sensor located in the distributer.


Where is the crank shaft sensor located on a 1996 S10 truck with a 2.2L?

under the coil pack rr of engine block


Where is the crankshaft sending sensor located on a 1996 Pontiac Grand Prix?

The crank sensor should be located down next to the crank shaft, Right side of car They are hard to see, and i think you have to remove the crank pully to get the sensor out, this is a comon problem on the 3.8 L Gm. eng Not a very expensive part, Usualy the car won't start when faulty


Where is the crank sensor on a 96 jeep Cherokee?

The crank sensor mounts to the top of the transmission bell housing on a 1996 Jeep Cherokee.


Where is the crank sensor located on a 1996 volkswagen jetta 2.0?

It is located almost adjacent to the oil filter and right beside the transmission bellhousing. The plug is located beside knock sensor plug attached to the motor mount.


Were is the crankshaft sensor on a 1996 olds LSS?

Does the LSS have a 3.8L engine? If so, the crank sensor is behind the crank pulley/harmonic damper.


Where is the crank position sensor located on a 1996 Toyota corolla 1.6L?

On the harmonic balancer that's attached to the front of the cranck shaft


Where is the crankshaft position sensor and the camshaft position sensor located on a 1996 ford e 150?

the cranck sensor is on front of engine it reads the teeth on crank pulley.the cam sensor is on top of same side of engine.


Where is the crank sensor on a 1996 Geo Tracker?

there isn't one


Where is the crank shaft sensor loacted on the engine for 1996 F-250 7.3 diesel?

The crank shaft sensor is located on front of block above the harmonic balance wheel (bottom pulley on front of engine). This is easiest to get at from underneath the vehicle.