0
crankshaft sensor on your excel (presuming it is a DOHC model) is at the front of the engine. there is a small connector you'll see next to the exhaust heat shield, follow the wire from the connector down the block a little bit and that is the crank angle sensor (not to be confused with camshaft angle sensor which is located on top of the engine just behind the coil pack and next to the rocker cover).
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor located on a 1996 Hyundai accent?
Crank Angle Sensor (location)i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front of the car,about 5"-8". hope this helps.
Why would your 1999 Hyundai excel drive fine until warm then stall and not start again until it has sat for 15 to 30minutes?
your crank angle sensor playing up.
Where is the crankshaft angle sensor located in a 1998 Mitsubishi carisma?
in timing belt
Where is the crank position sensor located on a Cadillac deville?
where is the crankshaft angle sensor located on a 1997 cadillac deville.
Where is the crank angle sensor on a 1998 excel twin cam?
at the back of the motor on drivers side
How do you change a crankshaft angle sensor on a 2003 Kia Sedona?
It's fairly complicated. The sensor is located near the bottom to the engine behind the crankshaft pulley and timing belt cover. Not a job for an inexperienced do-it yourself mechanic.
Why might a 1999 Hyundai Excel 5-speed manual surge at 100KMH but not on acceleration or deceleration if fuel system cleaner does not help?
hi i had the same problem in my 2000 model excel it turned out to be the throttle sensor i was told they go in these cars all the time i did the crank angle sensor as well yeh i had same thing also it was actually running it on premium fuel that caused it to surge
What does an angle crank sensor do in a Mitsubishi Galant?
Crank angle sensor reads rpm and sends the signal to the ECU (computer) to aid in the calculation of engine rpm, ignition timing, fuel injection and crankshaft position.
Where is the crankshaft position sensor located on a 1994 Mitsubishi Eclipse?
On a 94 Turbo DSM there is no crank angle sensor. The Cam Angle Sensor(CAS)serves the function of both a crank and cam sensor, and it's located on the passenger side of the valve cover at the end of the intake camshaft, you can't miss it.
How do you remove a broken crankshaft sensor that is flush with the bell housing on a 2003 dodge grand caravan?
Using an angle drill, drill a small hole in the sensor. Thread a screw in the hole, and use it to pull the sensor out.
Where is the cps on a Jeep Cherokee 96?
The Crankshaft Position Sensor is attached to the bellhousing.The CPS detects teeth on the flyweel as thay pass the sensor during engine operation and thus provides the computer with info concerning engine speed and crankshaft angle. Hope this helps.
What is the angle of departure of the 2014 Hyundai Tucson?
The 2014 Hyundai Tucson has a 26.9 degrees angle of departure.
