Oldsmobile Intrigue
Crankshaft Sensors
Ford Explorer XLT
1995-2005 Chevy Cavaliers

Where is the crankshaft sensor on 99 Intrigue 3.5L?

585960

Top Answer
User Avatar
Wiki User
2006-07-01 19:47:38
2006-07-01 19:47:38

Someone believes you should, "Take Your coolant tank off and the sensor is located under it. It's fairlly simple to replace once you find it."; You will find a sensor there but not the crankshaft sensor. On a 99 Intrigue with a 3.5L, the crankshaft position sensor is in the engine block just above and behind the starter. get under the car, remove the starter and you should find what you are looking for.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.

User Avatar

The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.

User Avatar

The crankshaft position sensor (CKP)is located on the front side of the engine block,near the flywheel/driveplate

User Avatar

you not need picture the sensor is next to the oil filter

User Avatar

Yes it has four.Yes it has four.

User Avatar

Back of the engine next to the coil packs.

User Avatar

The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate

User Avatar

That is where the crankshaft position sensor goes.

User Avatar

The crankshaft sensor for the 5.2L Chrysler models is on the transmission bell-housing. It is above the starter, I had to remove the starter in order to get to the sensor. After that it was a piece of cake.

User Avatar

just aside of the oil filter, threaded into the bottom front of block.

User Avatar

It is behind the starter. you can not see or get to it until you remove the starter.

User Avatar

It is in the upper right of bell housing , under the trans dipstick.

User Avatar

easy take old one off replace with new one! simples no

User Avatar

how do i replace a front crankshaft seal on a 99 mitsubishi mirage

User Avatar

On 01 Daewoo lanos 1.6l USA, the crankshaft position sensor it location on passenger side under car to the rear of a round gear called the crankshaft.it will be very close to this gear but will not be touch it as it uses the "Hall Effect" to detect the position of the crankshaft. This sensor should be location in the same location of all year models of lanos 99-02

User Avatar

if your fuel pressure is still good i would replace the crankshaft position sensor , it is located behind the crankshaft pulley, you will have to pull it with a puller.

User Avatar

Where is the knock sensor for a 99 pathfinder

User Avatar

i need a wiring diagram with pictures to help put my ignition switch back together on my 99 olds intrigue

User Avatar

On the top of the bell housing of the trans.. Look @ the engine its behind the left side head.. Look behind it..

User Avatar

This code is related to the CSF Sensor and it indicates NO signal from it. CSF = Crankshaft Speed Fluctuation This sensor connector is located below by the timing belt (under the intake manifold).


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.