ODB-II was first used in 1994.It was not standard until 1996.1993 was equiped with ODB-I
Answerthe OBD 1 port is usually under the hood either along the firewall or along on of the inner fenders.(if it's not under the dash) AnswerThere is no OBD-II port on a 1993 Accord. They were standard equipment in 1996+, although a few 1995 models had them. Answerthere is a plug next to the kick panel under the dashboard. Below the glove compartment. By using a paper clip or wire you can jump the plug. Turn the key to on and watch your check engine light flash. Long slow ones count for 1 and really quick ones are the second number. For instance, 4 long slow ones and 3 really fast ones equal 43on a pre 96 Honda the only way to get codes is by doing the above jumper wire method 96 and newer it could be found behind the ashtray
Oxygen sensor
Under the hood on the drivers side
under hood will say diagnostics on it should be driver side
how to change manual ignition switch on a 93 Honda accord
reset accord 93 computer
No, the only transmission that fits exactly is a 94-97 Accord. The 90-93 Accord can be used, but you will need the 90-93 flywheel. Chuck
where is the ac recharge port on a 93 ford explorer located?
4x114.3
Yes, I actually bought a 93 accord trans for my 96 prelude. The 91-93 accords have the same engine and trans as the 92-96 preludes.
There isn't. There are only diagnostic plugs on 94 and up
probably not, the accord layout changed quite a bit from 1987 to 1993
Port Charles - 1997 1-93 was released on: USA: 1997