Its a 3300 3.3 3.1?? drivers side rear coner of engine (top of). Its an electronic EGR with 3 valves on it. REmove it and check the passageway below it as it carbons up and will give you an EGR failure code/symptom
The EGR is the acronym for exhaust gas recirculation valve. The 1993 Cutlass Ciera does not come equipped with an EGR valve.
yes it is located on the top of the manifold, back side of the motor next to the throttle assembly shield. It is electronically controlled
The 1991 Geo Metro EGR valve can be located on the air cleaner housing. The valve will be on the back of the housing.
After removing an EGR valve from the vehicle, the valve can be flushed with carburetor cleaner. If the valve still sticks then a replacement will be needed.
The EGR valve for a Honda EX 1991 is at the top of the engine. It is at the front, just to the left of center.
They are not screws they are bolts either 1omm or 13mm
no the do not but some gaskets kits will come wit a egr gasket
The idle air control valve is located on the throttle body, and the EGR valve is located on the intake manifold.
Could be the idling sensor or the EGR Valve
Unless your car has California emissions, you do not have an EGR.
An ERG is a unit of work. An EGR is a valve that usually sits on the manifold and is controlled by a vacuum diaphram.
yes