More information is needed to answer this question properly, such as; is the engine a 4 or 6 cylinder. In the case of a 6 cylinder, their are 2 exhaust manifolds; the front exhaust manifold is located under the hood between the radiator and the engine: when you check your oil level by grasping the dipstick your hand will be just a few inches above the exhaust manifold. Basically, follow the exhaust pipe(s) to the engine and where it connects to a device that splits the exhaust 3 or 4 ways, that device is your exhaust manifold.
Finding the intake manifold runner control on a Dodge Avenger is easy. It is located near the engine.
No. They are in the exhaust pipe.
There are 4 02 sensors on your avenger. two coming off each side of the exhaust manifold and two more which are located...one before the catalytic converter and one after... you problem is most likely cause by the sensor on the driver side manifold
Driver side exhaust manifold.Driver side exhaust manifold.
on the end of the exhaust manifold just where the exhaust pipe connects to it
they are located right at the exhaust manifold
It is on the back exhaust manifold.
On the back of the engine.On the back of the engine.
Mistubishi motors of America builds the dodge avenger. so yes, the whole car is.
In the exhaust manifold on the back of the engine.In the exhaust manifold on the back of the engine.
Driver side of the engine, just below the exhaust manifold.
Changing a thermostat on a 2008 Dodge Avenger can be difficult because there area two thermostats. One is located under the intake manifold inside a housing unit, and the second is at the end of the radiator hose.