Oldsmobile Alero
Oldsmobile Ciera
Turn Signals and Hazard Lights

Where is the flasher module on a 1994 Oldsmobile Ciera?

414243

Top Answer
User Avatar
Wiki User
2006-09-22 17:27:15
2006-09-22 17:27:15

The flasher unit is behind the fuse panel in the wiring harness. To get to it, open the glove box and unscrew the T-15 Torx internal drive screw from the tether. The glove box door will open far enough to reveal the bottom two 8mm hex head cap screws holding the fuse panel in on the left side of the glove box. Remove all four 8mm hex head cap screws and wiggle the fuse panel out. The flasher I removed was a yellow cylindrical Wagner model with two prongs. Use a straight blade screw drive to gently pry the connector off the flasher unit.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.

User Avatar

The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.

User Avatar

Remove it and bring it to an auto parts store that can check it

User Avatar

Group size 75 with at least 650 CCA fits a 1994 Oldsmobile Ciera SL.

User Avatar

There is no flasher, it has a turn signal module under the seat, one bolt in the center holds a flat module, about 2 in by 3 in

User Avatar

The 1994 Oldsmobile Cutlass turn signal relay switch can be found below the dashboard. The relay switch will be on the drivers side of the passenger compartment.

User Avatar

Under the dash on the left side of the steering column/

User Avatar

the horn relay switch is in the fuse panel or it should be on the horn wires itself

User Avatar

pop the hood, off to the left, look under serp. belt. you should see it hiding.

User Avatar

The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.

User Avatar

There is none - usually it is the module in the top of the heater / blower box (resistor module) that is the problem.

User Avatar

In order to locate and replace the cylindrical shape flasher module, the four screws holding the fusebox in must be removed. The glove compartment door hinge is sort of in the way so it is best to remove glove compartment screws, though glove compartment door will still stay on. the cylindrical shape flasher module is located behind fusebox and it has to be searched for by feeling for it. In my case I found it by reaching behind fusebox to the left. I was told to first turn on my four way directional signal so that after I disconnected the cylindrical shape flasher module I knew for sure that I was not disconnecting the four way cylindrical shape module. Now the cylindrical shape flasher module that I removed was yellow in color and the one I bought to replace the cylindrical shape flasher module was silver in color. Getting the fuse box out took a little tilting and angeling to get out This information is 100 percent correct. Thank you. Remove the fuse box and the glove compartment and there it is. Cut the wire tie holding the flasher and replace. Thak you Additional Answer I just fixed mine last night, but I didn't have to mess with the fusebox. It turns out that the flasher was attached by a clip on the right side of the ashtray frame inside the dashboard. I took out the removable "cup" part of the ashtray, then removed the two upper and two lower ashtray frame screws. Next, I pulled the frame forward and disconnected the small ashtray light. The power wire for the cigarette lighter can stay attached. After that, it was easy to get to and replace the flasher unit.

User Avatar

The flasher module on a 1994 MK VIII is located to the left of the glove compartment. To access it, you must remove screws that hold the the glove compartment door hinge. After you remove the glove compartment, the flasher is mounted on a dash support beam to the left side of the compartment.

User Avatar

I have yet to identify which relay is specifically for the fuel pump,however, the relays are mounted on the passenger side of the radiator .

User Avatar

The solinoid is located on the top of the starter. Generally the starter is located on the front of the car, or the left side of the engine, next to the transmission.

User Avatar

where is cam senor on a 91 cutlass ciera 3300

User Avatar

its attached to the distributor, right at the base, should have two electrical plugs going into it, one from the coil

User Avatar

In order to locate and replace the cylindrical shape flasher module, the four screws holding the fusebox in must be removed. The glove compartment door hinge is sort of in the way so it is best to remove glove compartment screws, though glove compartment door will still stay on. the cylindrical shape flasher module is located behind fusebox and it has to be searched for by feeling for it. In my case I found it by reaching behind fusebox to the left. I was told to first turn on my four way directional signal so that after I disconnected the cylindrical shape flasher module I knew for sure that I was not disconnecting the four way cylindrical shape module. Now the cylindrical shape flasher module that I removed was yellow in color and the one I bought to replace the cylindrical shape flasher module was silver in color. Getting the fuse box out took a little tilting and angeling to get out

User Avatar

Hi,I have a 1990 and its located right above the int light on the pass side .I took the glove compatment out and then its easy to get at.

User Avatar

with in the fuse box,a roun flasher with in the fuse box,a roun flasher


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.