Look on the exhaust pipe coming off the manifold.
At the rear and 1 in the front. If it is 4WD
The minimum thickness for the rotors of a 2001 Mazda B3000 is 0.5 inches for the rear and 0.97 inches for the front. Falling below this threshold can result in poor braking performance.
it has 4 o2 sensors #1 cylinder is sensor 1 or bank 1 sensorType your answer here...
The starter on a 1996 Mazda B3000 is located near the battery terminal. To change it, first unbolt the negative cable from the battery terminal and raise the right front corner of the Mazda B3000 with a jack. Unbolt the starter wiring and thread the mounting bolts through the starter. Finally, reconnect the starter wiring.
2004-6 front in exhaust manifold top one, rear in cat on side.
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
The firing order for the spark plugs in a 2000 Mazda B3000 start on the passenger side. The order is as follows - passenger side front, passenger side center, passenger side rear, driver side front, driver side center, driver side rear.
The front oxygen sensor is located on the exhaust manifold of the BMW 318ti. The rear oxygen sensor is located in the head pipe.
The 2001 Toyota Tundra front oxygen sensor torque specification is 20 pounds. The oxygen sensor bolts should be torqued in 10 pound intervals.
Both oxygen sensors are located on the catalytic converters. Sensor 1 is in front of the front converter and sensor 2 is either at the rear of the front converter or the front of the rear converter. They are only a foot or so apart.
in front of the cat converter
This is not under the car, but under the front hood. It's actually right next to the fan. This is not under the car, but under the front hood. It's actually right next to the fan.