Honda Civic
Ford Expedition Eddie Bauer
Ford Expedition XLT
Honda Prelude SI

Where is the fuel pump relay located in a Honda SI 1988 Prelude?

464748

Top Answer
User Avatar
Wiki User
2006-04-02 11:34:20
2006-04-02 11:34:20

It should be under the dash and takes 5 mins to swap out, matushita RZ-XXXX it is called the "main relay" which does both the fuel pump and ignition. Assuming this is fuel injected. Just replaced mine in my 86 Si and it fixed problems with the pump not coming on all the time when starting. $70 from the dealer.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is the fuel pump cutoff relay located in a honda 88 prelude?

User Avatar

Yes you can I have 1988 Honda prelude with the 2.0L in it.

User Avatar

The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.

User Avatar

the oil filter is located on the back side of the block in the middle

User Avatar

my 1988 4ws Honda prelude idles low at 600 rpm

User Avatar

Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.

User Avatar

None of the dashboard lights work on my 1988 Prelude. Why?

User Avatar

Location of the Main Relay SwitchThe main relay is located under the drivers side dash panel, behind the fuse panel. There are four Phillips head screws holding the dash panel on and one 10 mm screw holding the main relay in. The main relay is usually marked MITSUBA or something similar and is about 3" X 1.5"

User Avatar

The 88 Prelude does not use a dual timing belt. It has a single timing belt

User Avatar

The throttle body diagram for the 1988 Honda Prelude is found in the maintenance manual of this car. It can be obtained as a print out from an automotive store as well.

User Avatar

It is your main relay. Its under your dashboard on the driver side. it is hard to see. its on the left side of the fuse box you might have to unscrew it.

User Avatar

The fuse for the heater and the CD player in Honda Prelude 1988 can be found using?รฆa fuse diagram. The diagram is available online and can be found by looking for '1998 prelude fuse panel diagram' on any search engine.

User Avatar

I just went through that exact problem with my 88 prelude, it was the ignition cylinder.

User Avatar

Hey they usually come with a 2.0 litre b20a motor

User Avatar

fuel pump cut off relay is located under the dash on the drivers side, pluged into the back of the fuse panel. it is gray in color with a metal back that is vented

User Avatar

The relay is a small plastic box ( 3'x1.5') is the only one of grey color. I located on the fuse box..under the steering column.

User Avatar

Yes it will fit, all of the twin cam third gen preludes 1988-1991 have the same motor config. You can even put the fourth gen vtec prelude motors in the third gen chassis with mount kits.

User Avatar

Yes, with some custom mounts for the engine and transmission. This can be expensive if you have a shop do the work for you.

User Avatar

Most of them just drive out. Get the new ones and you will see how they install.

User Avatar

If its a 4 wheelsteer model look towards centre of the car.

User Avatar

20 inches on the driver's side, 19 inches on the passenger side.

User Avatar

if its a 2.0 then 2.0 liters of oil! 2.0 is the engine size, a 1988 Honda prelude 2.0 holds exactly 4 quarts of oil, i just changed my oil today and it says that in the owners manual.

User Avatar

It's located on the side of the intake manifold (driver's side) near the master cylinder reservoir. It's white & attached by 2 screws & has a 2 wire connector.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.