According to the prints there are 2 possible areas. First is a C/B on the fuse panel. This is located on the left side of the drivers knee. The other more common option is behind the glove box. Remove the glove box and check to the right. You should see a connector block with 2 fuses, an AC and a Heater. The heater actually feeds the blower motor.
A 1991 Toyota 4runner is bigger than a 1990 4runner
it mounted on the throttle body
The heater blower motor can be found beneath the passenger side dashboard. Remove the wiring harness from the back of the blower motor. Remove the blower motor retaining bolts. Reverse the process to install your new blower motor.
ignore pls
You can access it by removing the three screws which retain the glove box and then remove the glove box itself. You then remove the duct between the blower motor assembly and the heater assembly.
it's the blower motor
go to the Toyota store n ask them if they don't no go on Google and type in this how toinstall rear speakers on a 1991Toyota 4runner
Open the bonnet, remove the scuttle cover, wiper motor, and finally blower motor.
faulty blower module. Under hood not far from blower motor
The blower motor is located on the passenger side up under the glove box.
The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
Typically, yes. Most 1990-1995 4runner's came with the same factory 3.0 V6 engine and are interchangeable.