in the fuse box
the bottom right side The oil pressure sending unit that makes either the light or gauge work is located behind the distributor.
yes but the speedometer might not work depending if it is a mechanical or electrical gauge. the trucks are electric and i believe the speedometer is mechanical in the caprice but the parts are interchangeable for the gauge
The dealer has to program it.
ect sensor bad
The fuse box for the fuel gauge on 1998 Chevy blazer is located on the driver side. It is near the hook latch.
The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.
This is an electrical problem that happens with a lot of Caprice classics with digital spedometers. My speedometer works about 1 day out of the month and the will cut off the other 30 days.
in the fuel tank
In the fuel tank. Fuel filter is inside the frame rail on the driver side just in front of the rear wheels. Fuel pump/gauge sender wire connections are underneath the driverside rear just behind the bumper.
1990 Chevrolet Lumina temperature sender is located on the back side of the thermostat housing. The sender has a wire that goes to the temperature gauge.
look on the right side of the block There are two, one, a switch that cuts the fuel pump off when the oil pressure drops, it is usally located behind the right hand side of the intake manifold, another that sends the signal to the dash light or gauge whichever you have, that one is located right above the oil filter
You do NOT reset an oil pressure switch. It has to be replaced and a special socket is required. Before doing so you will need to have an external mechanical gauge installed to be sure that you do have pressure.