The 1996 Mitsubishi Eclipse ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
its usally located up your bum
The coil is on the passenger side of the engine
It should be located on a tag under the hood.
If you remove the distributor cap, you will see it bolted on the base plate
Under the coil,check link below:
On top of the lower portion on the steering column.
howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy
The ignition module is located under the three ignition coils. The same bolts that hold the coils in place also retain the module to the mounting bracket. To find the coils, follow the ignition wires from the front of the engine to where they attach at the rear. The wires clip to the coils.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
I believe under the distributor . It should have a plug attached to it.
Fuel filter is located in the engine compartment, driver's side between battery and firewall. Follow the fuel lines.
on the 94 aspire the speed cable connects to the speedometer and goes through the firewall and to the wheel
Next to the wiper motor.
it should be located under the battery on the inside of the front fender.
The Ignition Control Module on a 1996 Ford Thunderbird 4.6 is located inside the EFI or Electronic Fuel Injector. The EFI is the carburetor. Look for a cord that has a connector that resembles an HD Cable.
The 1996 Ford Aspire has a 10 U.S. gallon ( 38 liter ) gas tank
A ( 1996 ) Ford Aspire has a 38 liter / 10 U.S. gallon fuel tank .
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil
The ignition switch, or "killswitch," for a 1996 Chevy Cavalier is located inside the steering column. Replacing or repairing it requires disassembly of the steering column.
Ignition what? Switch? Coil?