Want this question answered?
It is bolted inside the distributor under the rotor on bass plate
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Remove the distributor cap and it will be bolted inside the distributor on the base plate.
in the computer
how do you remove the ignition control module on a 1988 ford f-250 pickup?
Lower passenger side of engine block, the coils are attached to it.
The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.
PCM powertrain control module is located on the firewall on the passenger side. it has 3 large wire connectors.
If you remove the distributor cap and rotor you will see it bolted to the plate and it will have electric wires pluged into it. It will be on the right side of the distributor.
it's underneath the rotor in the distributor. you have to take the distributor out to change it.
If you mean the Power Control Module, it is located on the passenger side of the engine compartment, along the upper edge of the firewall.
In a 1988 Chevy pickup the ECM is located behind the glovebox.