it's on the lower section of the distributor!
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )
on the floor
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC
It is secured with screws at the fenderwell.
4.5 mm but has to be deepwell
How do you bypass the alarm on a 2000 Ford ranger cause I replaced the ignition
The ignition module should be attached to the distributor with two small machine screws.
Where is the key in the ignition warning chime module located on a 1990 Ford ThunderbirdRead more: Where_is_the_headlight_warning_chime_module_located_on_a_1990_Ford_Ranger_2.9
Yes ANSWER No - a 1998 3.0 L Ford Ranger does not have a distributor which would allow you to adjust the ignition timing - it has a coil pack and the ignition timing is controlled by the PCM ( powertrain control module )
Right in front of the battery, between the battery and radiator.