It is on the front of the transmission, between the cooler hoses.
The input and output speed sensors are located on the front of the trans. They have two wires and the input sensor is closer to the engine.
On the driver side of the transmission case there are two sensors that have two wires going to them. The input sensor is the one closer to the front.
There are two sensors located on the driver's side of the transmission. there is an input and and output sensor. You can get to them from the underside of the car.
is on the transmission It is the two wire sensor on the same side as the cooler hoses, closest to the engine.
yes the have a speed sensor a input and out put the input allow your transmission to change gears and the output speed sensor allow your speed to register on your speed domitor
There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.
It is a sensor on the transmission that reads the rotational speed of the input shaft.It is a sensor on the transmission that reads the rotational speed of the input shaft.
P0731 is 1st gear incorrect ratio. P0715 in the input speed sensor.Check the Input and output speed sensor located on the transmission. One or both are faulty. Input in on top towards torque conveter the output towards the end or driver side of transmisstion.
The output speed sensor on a 2002 Chrysler Town & Country AWD is on the side of the transmission. On the AWD models the tranny is mounted sideways and the sensor is behind the radiator on the drivers side under cooling lines and can be most easily accessed from under the hood, not under the car
Where is my veh.speed sensor input location
It's put near the Input speed sensor and i sure removed Hoses and it there. <a href="http://carcomputerexchange.com/chrysler/cat_1.html">Chrysler ECU Repair</a>
They are the two wire sensors screwed into the front of the transmission case.