answersLogoWhite
Car Computers and Sensors
Dodge Durango
Dodge Ram
Kia Sportage
Late Model 1979-New Ford Mustangs

Where is the intake temperature sensor plug for a 2000 Kia Sportage 2WD?

848586

Top Answer
User Avatar
Wiki User
Answered
2007-08-05 00:15:20
2007-08-05 00:15:20

It screws into the top of the air cleaner assembly near the braket for the mass air flow sensor.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


this has been answered in 2000 kia sportage.


it is in the intake manifold by the throttle body and the map sensor. it is a two wire sensor


It is the intake air temperature sensor , and it,s located in the air intake boot.


There are two, the ambient air temp sensor on the cold air intake just before the filter. And the Intake temp sensor on the intake itself (throttle body after the MAF.)


Intake Air Temperature Sensor. Located in the plastic air intake tube beside the battery.




On a 2000 Ford Explorer : YES ( the intake air temperature sensor / air charge temperature sensor should be in the rear side of the big rubber engine air intake tube , located between the engine air filter and the throttle body )


Look for a wiring harness and connector, that connects to the air intake tube. That is where your intake air temperature sensor is located


From 2001 to 2005 6.8L V10 Air Tempeture sensor is on the side of the air intake. I have a 2000 ford v10 I need to know where my air temperature sensor is?



The coolant fan sensor is the same as the sensor that shows the coolant temperature on the dash gauge. It is located on the intake manifold.


It could be your air intake temperature sensor or maybe your mass air flow sensor


2000 sportage it is right in front of the oil filter toward the front of the engine.


if you are standing in front of the hood then the sensor is ontop of the box just to the left of the actual filter.


Follow the upper radiator hose to the thermostat housing. The coolant temperature sensor for the ECU (2-pin connector) is on the driver's side. The temperature sender for the guage (1-pin connector. is on the opposite side.


On my 1998 zx2 it is located on the intake tube after the mass airflow sensor. It points to the front of the car and has two wires coming out of it.


its located on the air filther hose attached to the air filther housing


If not mistaken, it is on the right handside of the motor below the the intake manifold.


crank sensor should always be near bottom crank pulley


the knock sensor is under intake, must remove intake and it is under two coolant lines.


The MAP sensor is located on the intake side before the intake manifold.


the sensor is located on the left side of the engine above the header. you need to remove the air intake to see it, let alone get to it. hope it helped


It does not have a MAF, it uses a MAP sensor on the firewall above the intake.It does not have a MAF, it uses a MAP sensor on the firewall above the intake.


On rightside of intake platinum



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.