Right behind your brake rotor mounted on a dust shield. It comes as the sensor and shield with wires from General Motors. The left side IS different from the right. is there more than one vss
where is the oxygen sensor located on a 1997 Chevrolet lumina
Back of the engine, center, under the exhaust manifold. According to autozone.com
It is located in the transmission.
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
The Chevrolet Lumina speed sensor can be found on the back of the transmission. The exact position of the speed sensor is dependent upon the year of the automobile.
the back
its on the throttle body just above the throttle position sensor (t.p.s)
The speed sensor on a 90 lumina 3.1 should be on the drivers side top of the tranny, below the steering rod. Sould be a screw in sensor with wires attached.
It is installed on the top of the back side exhaust manifold.
If it is an automatic transmission it is most often the torque converter that will cause the jerking motion of the car.. another way to tell is the car will start to die when you come to a stop.AnswerI had the same problem in my 93 lumina euro... it's most likely the fuel pump. AnswerMy 92 Chevy lumina did the exact same thing, it turned out to be my crank sensor, and crack sensor wiring.
The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.
There are a few reasons. crankshaft position sensor, faulty fuel pump, fuel pump regulator, throttle position sensor, oxygen sensor. Need to have it diagnosed.