Ford Ranger
Mercury Sable
Pontiac Sunfire
Ford Explorer Sport

Where is the location of the Daytime Running Light Switch on a 1993 mercury sable 38 LT engine?

192021

Top Answer
User Avatar
Wiki User
2006-07-28 14:27:14
2006-07-28 14:27:14

This car does not have daytime running lights.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I'm guessing that you want to be able to turn off the daytime running lights on your car. As far as I know, there is no such switch on the Sunfire. The daytime running lights are on whenever the car is running and is in gear.

User Avatar

your headlamp switch on the dashboard has a small screw on it. its a 3 position switch. turn it to switch daytime running lights off.

User Avatar

Yukon daylight running the light relay switch can be located in the fuse box. The location of the fuse can be found on the inside cover of the fuse box.

User Avatar

The DRL system does not need to be "activated", it is automatic and turns the lights on at reduced power whenever the engine is running with the park brake off. If the lights you are looking at are down low in the bumper at each corner, these are fog lights. There is a switch just below the headlight switch. Some Mercury models required you to pull out on the headlight switch. Check the owners' manual for proper operation.

User Avatar

Turn headlight switch to the left to turn off daytime runnig lights. Turn switch back to left to turn back on.

User Avatar

they come on automatically

User Avatar

location for fuse, and relay switch on a Mercury Sable

User Avatar

You turn the headlight switch to the left when you start the vehicle.

User Avatar

The 2000 Toyota day time running the light relay switch can be found below the dashboard. The switch will be on the passenger side of the passenger compartment.

User Avatar

it is right across from my thermostat and i have a 2000 mercury cougur it srews in and out.

User Avatar

Well, the daytime running lights are on whenever the car is running and in gear. They're off when you have the headlights on. So, your service light Doesn't come on when the headlights are on?? If you switch the headlights between on and off (with the car running and in gear) does the service light follow?

User Avatar

To disable the daytime running lights on a 2008 Sequoia, turn the head light switch to the center position. It should show two headlights, one with an 'X' and a line between the two.

User Avatar

You can,t switch between high and low beam in DRL mode. Only when you turn on the headlights with the HL switch.

User Avatar

lever on left side on steering column has on off switch

User Avatar

Your 1991 Mercury fuel pump relay switch is located on the firewall of the engine compartment. The relay switch will be near the center of the firewall.

User Avatar

If the Explorer is running engaging the parking brake is supposed to turn the daytime running lights off , otherwise the daytime running lights are supposed to shut off when the engine is shut off . I have a 2004, Eddie Bauer Explorer. On the light switch itself, there is a selection to turn on or off the day lights, as well as the extended, courtesy lights after ignition is turned off.

User Avatar

The switch for the rear wiper is on the same lever as the front wipers. It's a circular switch that turns forward & backward.

User Avatar

The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.

User Avatar

hit your dome light on/off switch 4 times...it says how to do that in your manual

User Avatar

The daylight running lights of a Ford Explorer can be turned off by using the manual headlight control switch. Place the switch in the middle position to turn the daytime running lights off. The headlights will then need to be turned on manually at dusk.

User Avatar

Ensure relays and parking brake switch are properly functioning.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.