0
Where is the moonroof motor on a '96 Bonneville and how hard is it to replace?
Wiki User
∙ 19y ago
The motor for the sunroof will be on the back side of the roof. The only way of getting to this is by dropping the headliner out of the car. Once you have the headliner out, there will be two screws or bolts that holds the motor in. remove the two screws and the motor should drop down,then just unplug your wires and you will be able to replace it then.... GOOD LUCK.
Wiki User
∙ 19y ago
Add your answer:
Earn +20 pts
Are motor mounts hard to replace on a 2005 pacifica?
there hard to change on anything
How hard is it to replace a blower motor on a 1995 ram van 2500 with diagram?
It's not hard, it's very easy.
Could you change your 95 Cavalier windshield wiper motor by yourself or is it too hard?
no ! you can replace this motor , it`s very easy
What would cause a humming or howling noise coming from the engine compartment of a 1989 Pontiac Bonneville on hard acceleration?
sounds like a motor mount is broken or a transmition mount. have those checked.
Is it hard to replace intake plenum gasket on 1994 3.8 Pontiac Bonneville?
no, it is very easy, it just takes time, plan on aprox. 6 hours so you do not feel rushed.
How hard is it to replace a ac heater fan motor in a 97 Honda crv?
The heater in the CRV Honda is not working . How do I fix this
How do you remove voltswagen cabrio power window motor?
Buy a chilton's or haynes maintenance manual. They tell you everything. I had to replace my drivers side window motor. Not too hard.
What is the location of the motor mounts on a 1997 Mercury Mystique and how hard they to replace?
These are sideways motors so the replacements of the motor mounts is not an easy job. I suggest that if you can not find them you should not try to replace them. There are two at the top of the motor at both ends. (near both fender wells. And then there are mounts on the transaxle. (transmission).
How do you replace the water pump on a 1994 Pontiac Bonneville?
Remove the 6 bolts that hold the water pump on, possibly needing to unbolt the motor mount if it's in the way.Thoroughly clean old gasket material from the engine mating surface without scraping so hard as to gouge or leave deep scratches.Replace gasket and new water pump.Refill coolant as necessary.
How do you remove the oil fill tube to replace the engine cover on a 1996 Bonneville SSE 3800?
It just screws on like the oil cap. Sometimes can be a bit hard to turn. Use a pliers if you cant turn it by hand.
How do you replace the clutch on a 96 mx-6?
youre best bet is to pull the motor. I had to to do my clutch. these cars are hard to work on. no room for anything.
How hard is it to replace the fuel gauge sending unit on a Pontiac Bonneville?
Should'nt be that tough. You have an access cover in the trunk under the carpet on the right side. Pull out the fuel pump and the fuel guage sending unit is part of the assembly.
