Hi. It is located at the bottom of the oil pan near the back of the oil pan. It is mounted on an angle. It requires a 5/8" or 16 mm wrench to remove. Hope this helps.
Drain plug for what?
the drain nipple is on the bottom of the radiator on battery`s side.
where is the radiator drain plug on a mercury villager
The oil drain plug is located on the lower right side of the oil pan. You can easily get to the oil drain plug and oil filter by removing the right front wheel.
Drain the system from the lower hose on the rad.
where is the drain oil plug on a 2010 9.9 mercury outboard motor
Remove the drain plug from the bottom of the oil pan, and then remove the filter.
If you have one installed, on the 2.3 L engine, it would be in the back of the engine, looking at the engine from the front of the car. Its in the frost plug.
Its on the bottom of the oil pan.
The oil drain plug on a 1993 Acura Legend is 14mm x 1.5
There is a drain plug in the transmission pan.
gap them at .54 I have a 1993 Mercury Topaz with the 2.3 Liter I-4. The recommended gap is .044 (44 thousandths). I highly doubt that the plug will fire with just over 1/2 gap as recommended earlier. The correct gap should be listed on the emissions label under the hood. I have a 1993 Topaz with the 3.0L V6 and the label on my car is on the body piece in front of the radiator. Mine listed a recommended 0.042" - 0.046" gap. I have mine set at 0.044"