Front drivers side of the engine. Behind the alternator. Hard to see and get to. It has a white plug with one wire. Fords oil pressure sending units are not real sending units. Your oil pressure gauge is a glorified idiot light. Its either on or off, always in the middle. I put a real pressure gauge in mine.
I'm not a mechanic / technician but I believe on a 2003 Mercury Mountaineer , 4.0 liter , SOHC , V6 engine that the oil pressure sending unit is on the front of the engine in the area where the lower radiator hose connects to the water pump
The oil pressure sending unit is located right above the oil filter.
Oil Pressure Sender and SwitchFord Ranger/Explorer/Mountaineer 1991-1999 Check Related Links below.
Your engine oil could be low check it when it cools and if level is fine your oil pressure sending unit could be bad or engine in need of rebuilding
Did you check the -- sending unit !!
The oil pressure sending unit is located on the back of the block. it is the sensor located closest to the alternator.
On a 1997 Mercury Mountaineer , 5.0 liter ( 302 cubic inch ) V8 engine : The engine oil pump is INSIDE the engine oil pan According to my Haynes repair manual in order to remove the oil pan ( to get access to the oil pump ) THE ENGINE HAS TO BE REMOVED * the engine oil pressure sending unit is on the OUTSIDE of the engine beside the engine oil filter
The 2003 Cadillac Deville oil pressure sending unit is located on the left-hand side of the engine. The oil pressure sending unit will be three inches above the oil pan.
The coolant temperature sending unit on a 97 Mercury Sable is in the engine compartment. It is located on the intake manifold.
On the 4.0 L OHV engine, the oil pressure sending unit is on the driver's side of the engine, located below the power steering pump.
near the oil filter
You lift the vehicle and lower the fuel tank. The fuel sending unit is removed from the top, and the pump can be wiggled out of the unit.
I have a 95 and the unit is located on the oil filter housing assembly. It is just a little ways up from the oil pressure relief valve, which is facing towards the ground. The sending unit has a wire/tube attatched. The attached end sholud be facing toward the front end of the car if I remember correctly.
Where is the oil pressure sending unit located on a 2004 4.8 L V8 GMC?
Oil Pressure Sending Unit LocationBuick positioned the oil pressure sending unit on the engine block, just below the power steering pump.
It's located by the oil filter
located below the oil filter
The oil pressure sending unit is located on the oil filter bracket about 9 inches above the filter.
The oil sending unit in a 1992 Isuzu Trooper is located within the car's engine. The oil sending unit is responsible for determining the oil pressure.
Its located in front of the oilfilter on left side of engine
The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.
The Oil Pressure Switch or Oil Sending Unit (which ever you prefur calling it) on 2.5L its located about underneith the Thermostat Housing.
Oil pressure sending unit is usually located just above the oil filter, right on the oil filter fitting stem.
The oil pressure sending unit and the oil sending unit are the same. It is located almost directly under the alternator. Remove the alternator and removal is simple when you have the correct socket.