It should be on the passenger side of the engine in front of the oil filter. Should look something like this http://info.rockauto.com/SMP/SMPDetail3.html?PS186.html Hope This Helps.
its a ct26
The fuel filter on a 1989 Toyota Supra is located just below the fuel tank along the vehicle's frame. It is positioned inline and must be replaced periodically.
153624
Yes, but a 7m-ge W58 bellhousing and a 7m-ge W58 flywheel will be required. There are also differences in the throwout bearings, make sure to get the correct one for the pressure plate you will be using. www.driftmotion.com
If they are square, YES!. If they are round, NO!. In 1989, Toyota did a mid year crossmember/engine mount change. The square ones will fit '86 to '89. The round ones will fit '89 to '92.
1986.5-1992 (1987-1993 in Japan) Toyota Supra MkIII (MA70)1989-1992 Toyota Cressida Mark II (MX83)Toyota ChaserToyota Crown
i would check the oil pan if its not there check the front of the block just above the oil pan if its not there then it will be near the oil filter
Computer is set for premium,and it performs much better on premium.I have a supra turbo tried both, went back to premium better mileage and performance.
On the outside both of them are on the molding. On the inside the switch is on the left and looks like a windshield wiper switch.
firing order for 7mge & 7mgte is 1 5 3 6 2 4
passenger side under glove box remove small panel and is located in fuse block.
above the oil filter to the back alittle