how do you replace a CV joint on a 1992 Chevy pickup?
1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.
Not from the factory, it doesn't.
The size of the front ring gear in a 1992 Chevy pickup is 7.5 inches. The 7.5-inch ring gear needs a 26 spline axle shaft.
Please be more specific.
Click the link.
Not without fabrication.
how much can a cheve s10 1992 pull ?
YES, All the cabs are the same from 1988 to 1999
Inside the dashboard, to the right of the glove box.
173 FT. LBS.
4 x 43/4
16 inch rims
the fuel pump on a 1992 Chevy pickup is located inside the gas tank but is attached to the top side of it. you have to drop the gas tank to get it out but up want to make sure that there is not much gas in there when you do it because it will be extremely heavy if you don't.
um..........i have NO idea
No. Air bags were introduced on the 1995 S10 Chevrolets.
I would replace the ignition module in the distributor.
on mine, I had to drop the gas tank.
under the dash passenger middle ish
When you will be sustaining a speed of over 45 mph
There is no fuel pump reset button on that vehicle.
Look behind passenger side kick panel.
That year model did not have a modulator valve on the transmission.