The front top valve cover has 2 pieces (main cover and pcv cover). The PCV is located under the small cover (has a 6 inch hose attached to it) on top of the front valve cover . If you look at the front valve cover, you'll see four (4) bolts. The two outer bolts fasten the valve cover to the cylinder head. The two inner bolts hold the PCV cover to the valve cover. To gain access to the PCV valve, you remove the two inner bolts and remove the PCV cover, leaving the valve cover fastened to the cylinder head. It might take some "persuasion" to get the cover off. Once you have the PCV valve cover off the valve cover, there will be a large square seal (looks like a big o-ring) that seals the perimeter of the PCV cover. There will also be two o-rings that seal the PCV cover bolt bosses to the valve cover. The PCV valve is located on the right side of the opening. You can't miss. Just unscrew it and spray some WD40 on it and work it around. Pick up another PCV cover o-ring and the two o-rings located underneath the cover bolts (3 seals total) at the dealer or parts store. They're probably hard as stones by now.
How do you bleed the cooling system of a 1988 acura legend? Is there a bleeding screw and where is it located?
Why 1988 acura legend downshifts
99 acura Ti
The fuel filter for a 1988 Legend is located under the hood. It is bolted to the firewall near the top of the engine.
"Considering that there is no such thing as a 1998 Acura Legend, I would dare say that it is impossible." I have a 1988 Acura Legend LS and I am dealing with the same issue. If you figure it out, help me out!
Some parts are, the 2.7liter is but some of it's electrical components are not
It is important to use the correct amount of fluid in a car. The 1988 Acura Legend takes about 3.2 quarts of transmission fluid.
1988 Honda acura legend S-3 light keeps coming on what should I do
the starter is located at the right side of the engine if you r looking at it from the front the starter is located at the right side of the engine if you r looking at it from the front
check ehow.com cars-repairs
under the steering wheel i guess
The firing order for a 1988 Acura Legend is 1-4-2-5-3-6Additional info FYI: Ignition timing: 15 degrees BTDC #1 cylinder location: RIGHT-REAR
IF BOTH ARE 4 DR/2 DR YOU SHOULD BE ABLE TO INTERCHANGE BETWEEN THOSE TWO YEARS **********************KKODAL********************************
It's under the driverside dash, towards the left..
There is none.
no a Philips screw driver and a 10mm socket
SPARK PLUG GAP1988 Acura Legend 2.7L FI SOHC 6cylThe Spark Plug Gap.044 (In thousandths of an inch) Caution! Gap is not adjustable on certain plug brands
1-4-2-5-3-6 the distributer turns counterclockwise
the fuce for the brake lights is located in the kick panel, witch is also located on the drivers side left were your feet rest when you drive, also this is known as the fuse panel. you will need to remove the 3"x3"cover in order to get to it
Facing the front of the truck, it is located on the intake manifold on the right side of the carb.
It should be at the base of the throttle body.
It is located in the top of the motor with a rubber tube/hose going to the air cleaner I believe.
1-4-2-5-3-6 the distributer turns counterclockwise hope i understood you right.
Directly behind the power steering pump. There is a 5/8th hose, pull up from valve cover.