Crankcases and PCV Valves
Geo Prizm
Chevy Prizm

Where is the pcv valve on a 1993 GEO Prizm?

666768

Top Answer
User Avatar
Wiki User
Answered
2007-06-22 16:31:00
2007-06-22 16:31:00

Your Prizm may not have one. Check the valve cover or the intake valve cover on twin cam For a vacuum hose leading to the intake. The PCV should be installed in the cover with hose connected. If cover only has tubing permanently mounted then you vehicle has no PCV valve.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Do you mean the PCV (Positive Crankcase Ventilation) valve? The PCV valve should be on the top of the motor, either in one of the valve covers or in the coverplate on top of the block.

do you mean the PCV valve? the PCV valve is located in the intake manifold

most all pcv valves are located on the valve cover

The PCV valve on a 1993 F150 is located in the top of the valve cover. it is a plug in type, and is easily replaceable.

Did you ever find the location of the pcv valve?

pcv valves are always located on valve covers (but not all vehicles have pcv valves)

The 1999 Chevy Geo Metro 1.0 liter engine PCV valve can be found on top of the engine. The PCV valve will be behind the air cleaner housing.

some models the pcv valve is in the valve cover on others the valve plugs into intake manifold and is connected to valve cover by hose

It's either in the intake or in a hose between the intake and valve cover.

On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.

Pull straight up on the PCV valve to remove it from the valve cover, then pull off the hose from the PCV valve, install the new one by doing the opposite of removal.

The PCV valve is located on the back side valve cover. It should be a plug in type and easy to change.

pass.side valve cover at the rear

PCV VALVE - Under hood, center, upper engine area, mounted in intake manifold

AnswerIt doesn't have a PCV valve.Actually it does. The PCV valve for a 1993 Nissan Altima is located behind the engine below the intake. Buy a Haynes manual, the PCV is VERY tough to get too but it can be done. You can only get two bolts from the top but have to go from underneath the car to detach the hose.

located at front of the car-on the thing that holds air breather.

Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.

Pull upward on the hose that the PCV valve is in. The PCV valve will pull out of the hose. The PCV valve is located in the valve cover.

on the back side of motor by firewall

It's mounted on the throttle body.

It is inside the air intake with the air filter.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.