Unplug the electrical connector from the switch and remove the switch with a socket DO NOT use an open end wrench.
Installation is the reverse. Tighten the switch to 24 Ft. Lbs.
To change the reverse lights on a Pontiac Sunfire you need to locate it on the left side of the transaxle. Then, unplug the electric connector and remove the switch along with the socket.
Check the bulbs, check the fuse then check the switch.
According to my Haynes manual, the reverse light switch is located on the top of the left end (driver's side) of the transaxel.Unplug the electrical connector from the switch and remove the switch with a socket DO NOT use an open end wrench.Installation is the reverse. Tighten the switch to 24 Ft. Lbs.FriPilot
Turn the wheels all the way to the right. Look between the back of the driver side wheel and the fender. You will see the reverse light switch just above the transaxle.
How is the ignition key switch replaced on the 2000 Pontiac Sunfire? And after replacing the switch would I have to have it Towed to the Pontiac Dealer in order to have the car key programed to the Computer?
Pulling the turn signal switch toward you should switch the lights to the low beams. If that doesn't work, you may have to replace the switch, which means replacing the entire turn signal stalk.
under the dash
The neutral safety switch is found under the clutch pedal on a Pontiac Sunfire. Crawl under the cars steering column to see and reach the unit.
is there a emergency switch that shuts the fuel pump down
Try bypassing the reverse light switch that plugs into the transmission. If your reverse lights come on, voila! Problem solved. Buy a new switch.
On the column accross from the key lock cylinder
What, exactly, is the problem?