It is located on the side of the transmission that is toward the rear of the car. You can follow the brake fluid line that leaves from the lower part of the master cylinder and it will lead directly to the slave cylinder.
On my 1998, the slave cylinder is located inside the bell housing - a very stupid place for it IMO. If you are replacing the slave cylinder, it might be a good time to replace the clutch too.
Under passenger side of truck right below the starter. The slave cylinder for the clutch is in the Transmission Bell housing. You have to remove Transmission to repair it.
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
the clutch slave cylinder on this car is located inside the transmission itself. The part has a rubber bushing that separates the the hydraulic lines and bleeder, from the section that is located in the transmission housing itself.
Inside the transmission
The inline fuse on a 1998 Kia Sportage will be located in the exterior fuse box underneath the hood.
This means that your engine is misfiring on cylinder #3. It is either a bad sparkplug, wire or coil.
what is the torque cylinder head bolts and the camshaft for KIA clarus 2.0 petrol DOHC 1998 model
next to stater is where slave cyl. is bleeder is under passanger side
How much labor will cost a person in order to install a clutch slave cylinder on a 1998 S10 will depend upon how much labor charges are. It should take a mechanic no longer than 30 minutes in order to install the clutch slave cylinder.
The slave cylinder is inside of the bell housing, I'm presently working on mine now, my lines are loose, this is aparrent from outside of the bell housing, I'm going to see if there is a way to fix this without pulling the transaxle at this point... Bill.
The ignition coils only go over the #2 and #4 spark plugs