0
It is on the fire wall close to the master cylinder, and it is small.
Whoever wrote this is totally wrong very wrong
the clucth slave cylinder is located inside the transmission
you need to remove the transmission and that is the only way to replace slave cylinder because you have to slide out the cylinder from the input shaft after you remove the mounting screws also there is a trick to remove the Hydrolic line you can use special tool or use two flat head screw drivers put each on both side and push toward transmission and have a friend pull out the line anyway special tool only cost like $5.00 and good luck
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What are symptoms of timing belt slips on 2002 Chevrolet s10?
The 02 Chevy S10 with a 4 cylinder or a 6 cylinder does not have a timing belt.
Where is the slave cylinder on a 2002 Chevy S10?
the slave cylinder is bolted to the drivers side of the transmissions bellhousing,the reservoir for it is on tne drivers side firewall
Carburetor componets on 2002 Chevrolet s10?
The 2002 Chevrolet S10 was fuel injected.
How do you replace the clutch cylinder slave in a 1997 Chevrolet S10 pick up?
Replacing the clutch slave cylinder requires removing the transmission assembly. I would recommend purchasing a shop repair manual for that vehicle if you intend on DIY.
Where can you buy a steel replacement line from the clutch slave cylinder to the clutch master cylinder for a 1994 Chevrolet S10 pick up truck?
Napa Auto parts for around $52.00 for the line for the slave and mater assembly around $200.00
How do you connect the hydraulic to the clutch slave cylinder on a 2000 S10 chev pickup 2.2 4 cylinder?
how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder
Where is number one cylinder 1992 Chevrolet s10 4.3?
First cylinder in front on drivers side.
Where is the slave cylinder at on a Chevy 1991 S10?
Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.
Why is clutch fluid leaking between transmission and motor on 1991 Chevy S10?
The clutch slave cylinder is probably at fault. Replacement is necessary to fix problem. Transmission must be removed to gain access to the slave cylinder.
How and where do you change a slave cylinder for a 1993 Chevy S10 manual pick up?
The slave cylinder on my s10 in on the driver side of the transmision. There are only 2 nuts that have to be removed to take the slave cylinder off. Then u must take out the pins to remove the clutch line.. Hope this helps
How many spark plugs does a 1997 Chevrolet s10 have?
One for each cylinder, six in a six cylinder, four in a four cylinder.
Where is the slave cylinder located on a 2000 Chevy S10?
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
