Rear end of the engine - front end of the transmission
Remove it from the car OR It can be flushed by a knowledgeable person with the correct equipment.
Yes if they both have the same engine size and both are either 2wd or both are 4wd.
All of the torque specifications for vehicles can be found in Haynes Repair Manuals available at most auto parts stores.
Looking from the balancer to the rear of the engine it is at the front of the dist on the right.
Tighten in 3 stages: 1, 130 Nm 2, slacken off 3, 20 Nm+90 cape
There is no code 91. The codes start at 12 and stop at 53.
a 91' or 92' Ford Taurus.
depends on what your changing. all ford parts have a stamping # on it ie iac motor e9se-9f715-aa if its the same them yes if its differen then rule of thumb is no
If it's the Vulcan engine, it doesn't have one
A Bosch O2 sensor, from NAPA, is $91 here in southwest Washington.
I was looking at my Chilton's Auto Repair Manual and it shows for a 1991 Ford Taurus either the ( 16.0 U.S. gallon tank or the optional extended range tank which is 18.6 ) It doesn't specify the station wagon
I was looking at the 2011 Ford Taurus Owner Guide and it shows that the SHO engine is designed to run on regular unleaded , 87 octane or higher but for best performance use premium unleaded , 91 octane or higher
I would have to say say some older model Taurus 82-91
I've heard from reliable sources that the B3 Ford Festiva 1.3 liter motor produces 63HP and appx. 76 foot pounds of torque, a lot for a 4 banger this is why its an adequate match for the 1.5L 88HP Civic
I was told by a transmission company that the 1992 tranny can only be used for 1992 Taurus models, no exceptions.This is correct the axode in a 1992 3.0 Taurus has different bulk head connectors from valve body,it won't work.As well the 88 is an axod not a axode.
That must be some weird car because I'm pretty sure Ford dropped the 4 cyl engine in '91.
Swapping transmissions in a Taurus can be difficult because of all the changes ford made on these cars.For example 1991 and 1992 Taurus 3.0 liter transmissions are both axod-e but are not interchangeable because of electronic bulkhead connectors.Best to check with a transmission shop,most are happy to provide this information.