0
On four cylinder models, the water pump will be attached to the timing cover on the front-side of the engine. Typically behind the fan clutch and pulley.
On six cylinder models, the water pump is typically in a similar location, but additional accessories may need to be removed to access it.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the water pump located on a 1986 Mazda b2000 pickup?
It is behind the timing case cover behind the crankshaft pulley.You have to remove the timing belt to replace the water pump for this repair.
What is the wheel size on a 1986 Mazda b2000 pickup truck?
The 1986 Mazda B2000 pickup truck has 14"x5.5" rims. The OE tire size is 205/75R14, and 195R14 tires also fit ideally.
Where is the blinker relay located in a 1986 Nissan pickup?
The blinker relay can be found in a 1986 Nissan Pickup in the engine compartment on the fender wall. There are several relay switches located next to the battery.
Where is the fuel pump located on a 1986 Mazda 626?
in the gas tank
Where is the gas float located on 1986 Chevy pickup?
It is inside the gas tank.
Fuel pump located at on 1986 4x4 Toyota pickup?
its in the gas tank
Where is the location of a flasher for a 1986 Toyota pickup?
The 1986 Toyota pickup flasher relay switch is located beneath the dashboard on the drivers side of the passenger compartment. The flasher relay switch will be labeled as such.
Where is the cruise control servo located on a Mazda 1986 truck?
to the right of the brake booster
Where is the engine temperature sensor located on 1986 Mazda b2000 truck?
under the termostat housing.
Where is the Ignition Module located on 1986 Mazda B2000?
Inside the distriburator after you remove the rotor button.
Is a 1988 Mazda B2000 a 4 cylinder?
Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.
Where is crankshaft positioning sensor located on 1986 ford van?
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
