Follow the serpentine belt, looking directly under the Power Steering pump....there u go!
Answer 1988-92 Mazda 626The water pump is connected to the timing belt. Remove AC unit, belt for AC and PS, slide PS hoses toward front of car. Remove the cap on the engine that is connected to the hose trailing to the bottom of radiator. Let water drain from hole in engine. Remove alternator belt(for access to screws). Remove timing belt covers.The bottom section has the gear for the water pump and the two timing belt tensioners. View here
hope this helps.
The 1999 monster 626 water pump is located on the front of the engine. You can follow the top radiator hose directly to the water pump.
On a 1997 Mazda 626 4-cyl, the (electric) fuel pump is located inside the gas tank.
in the gas tank
The water pump from Mazda 626 is the same, all part from Mazda 626 work very good in the Kia Credos and Clarus.
On a 1988 Mazda 626, the fuel pump relay is located in the fuel tank. Always disconnect the battery before beginning work on a fuel system.
It's inside the gas tank...
The fuel pump relay on a 2002 Mazda 626 is located in the engine compartment on the driver's side. It is in a bank of relays just behind the battery location.
Where is the thermostat located on a 1999 Mazda 626?
The fuel pump is located in the fuel tank. The tank will have to be removed in order to remove the pump.
About $500.00
You have to remove the fuel tank the fuel pump is located on top of the fuel tank.
To change the water pump on a 1996 Mazda 626 you have to follow a few step. First you disconnect the miscombobulater from the alternator valve. Then you take the water pump off and put the new one on. Lastly you re -attach the miscombobulator and the altornator valve. There you have it.