Auto Parts and Repairs
Chevy S-10
Geo Metro

Where on a 1992 Geo Metro is the IAT sensor?

798081

Top Answer
User Avatar
Wiki User
2005-04-15 01:12:46
2005-04-15 01:12:46

on a 3 cyl.metro,the iat sensor is found on the air cleaner housing towards the rear of the assembly

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

connected to the air cleaner housing

User Avatar

The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.

User Avatar

The IAT Sensor on a 1992 Geo Tracker is the Intake Air Temperature Sensor. Replacing the air filter might fix this problem.

User Avatar

The IAT ( Intake Air Temperature ) sensor is located on the back of the air cleaner housing.

User Avatar

The 1992 Chevy 5.7 liter engine IAT sensor can be found on the back of the engine. The IAT sensor will be near the top of the transmission.

User Avatar

That year did not use a IAT sensor, That's why you can't find it.

User Avatar

airbag sensor and iat sensor are not the same thing... wiki

User Avatar

it'll run very badly in cold weather, and may stall due to excess fuel in warm weather

User Avatar

rear of engine compartment near the bulkhead

User Avatar

The IAT (Intake Air Temperature) sensor measures the temperature of the intake manifold. The ECM uses this sensor reading to set injection timing and adjust the air-fuel ratio. If the fuel mileage and power output of you engine seem low, some owners have found improvement in EGT, fuel economy, and power after cleaning carbon from the IAT sensor in at the rear of the intage manifold. Engine with exhaust brakes are particularly prone to IAT sensor fouling because soot is blown back into the intake during valve overlap.

User Avatar

ok, I have the haynes geo repair manual it says code 23 , manifold air temperature (mat) /intake air temperature (iat) sensor circuit code 31 & 32, manifold absolute pressure (map) sensor circuit the above sensors eather need to be replaced or checked for problems with the sensor.

User Avatar

iat sensor on a 97 blazer and what does it do

User Avatar

The 2003 Forrester IAT sensor can be found on the top of the transmission. The IAT sensor will be near the back of the transmission.

User Avatar

The intake air temperature sensor on a Geo Prism would be a part of the air intake system. More specifically, it would be on the engine side of the air cleaner housing.

User Avatar

where is the IAT Sensor on tne 2002 maxima

User Avatar

The IAT sensor in most GM vehicles is mounted in the air cleaner housing. Will be a small sensor with two wires running to it. Usually just clips in.

User Avatar

iat sensor? Please describe this device, never heard of iat sensor. Post again

User Avatar

The IAT sensor is an integral part of the MAF sensor

User Avatar

Most of the IAT sensors are part of the MAF sensor it is a dual sensor

User Avatar

The 2000 Mazda IAT sensor can be found on the back of the engine. The IAT sensor will be just above the bell housing.

User Avatar

The IAT sensor is located in the intake manifold

User Avatar

On a 1998 Cavalier, the IAT sensor is located in the hose connecting the air cleaner to the throttle body. The IAT is a two-wire sensor.

User Avatar

The 2002 Saturn IAT sensor can be found on the top of the engine. The IAT sensor will be near the injector fuel pump.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.