If your Toyota has a manual transmission, the fluid will be put in by removing the gearshift, and literally pouring the fluid into the cavity under the shifter.
A 1984 Toyota pickup will not go into gear if the transmission fluid is low or the linkage is not adjusted. The fluid must be checked with the engine idle and at operating temperature.
there should be an upper and lower bolt on the underside of your transmission. undo the lower bolt to drain the fluid. undo the upper bolt and put some fluid in to drain the old. tighten the lower then fill to the hole. tighten the upper bolt
ask the guy at the parts store
no fluid in reservoir due to leaking reservoir or slave cylinder
should but check with junk yard they have the book
It should be a 700R4
Use a funnel and put the fluid in the same hole as the the dipstick where you check it... This is for automaitc of course. If i goes in slow or not at all the vent is plugged on the top of the transmission....This can also cause the trasnmission to "blow off" fluid through the seals.
ask tyler kincey
Most likely causes are low transmission fluid level, dirty transmission fluid, or clogged transmission fluid filter.
transmission fluid is getting into engine in our 1984 ford f 150
When I serviced my transmission, I bought fluid and parts from the dealer. It is a special "synthetic oil" fluid.
Automatic Transmission fluid