0
At TDC compression it points to the number one post on the cap.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you set initial timing on a 96 dodge Dakota 3.9L after timing chain and distributor have been replaced?
Crank on tdc#1. point rotor in distributor at the line on the pick up plate.Crank on tdc#1. point rotor in distributor at the line on the pick up plate.
What position should the distributor be at tdc on 98 4.0L jeep grand Cherokee?
At tdc compression it should be pointing at #1 on the distributor cap.
DIstributor rotor location at tdc on a 2001 blazer?
rotor should point at number 1 plug lead when engine is at tdc make a mark with whiteout ,on outside of distributor before you remove distributor cap. make this mark where the #1 spark plug lead would be if distributor cap was on distributor when you remove cap this is where rotor needs to be pointing
What position should the plug on the distributor be in at TDC on a 4.3 Chevy?
The rotor inside the distributor should be pointing at the #1 spark plug.
Where does the rotor point to when its top dead center on a dodge 318 1985?
rotor will point to #1 at TDC.
What direction does the rotor point in a 2.8 V6 Chevy S-10?
With the #1 cylinder on top dead center (TDC) of the compression stroke, the rotor should point to #1 on the distributor cap.
How do you set ignition timing on 1997 dodge ram 5.9?
Set the #1 cylinder at TDC on the compression stroke. Adjust distributor so that the rotor point directly at the #1 spark plug wire in the distributor cap. Any deviation will be corrected by the PCM. You're done.
What is the timing setting for 265 hemi?
5 degrees before TDC
Does the rotary button on a 305 always have to point to the number 1 cylinder when it is at TDC on the compression stoke?
WHEN INSTALING THE DISTRIBUTOR THE ROTARY BUTTON HAS TO BE POINTING AT THE NUMBER 1 CYLINDER AT TDC
How do you set the timing on a 1997 dodge 2500 with a 318?
The distributor is set to 0 deg. Align the rotor to the line in the pickup plate in the distributor when the crank is at tdc. The dist. is then fine tuned with a scan tool.
Why would your rotor be pointing at the 6 position on the distributor when the 1 cylinder is TDC?
once the number 1 piston is on tdc which ever point the rotor is facing becomes the number one position. if you conect the wires from there and follow your firing order you should have no problems.(i have done it)
1994 dodge Dakota base ignition timing 5.2?
The distributor is set at 0 deg with a scan tool. The "base" timing is to line the rotor up with the line in the pick up plate in the distributor when at tdc.
