0
Where to locate and replace a speed sensor on a 1999 Chrysler Cirrus engine?
Wiki User
∙ 14y ago
The Speed Sensor (for 2.5 V-6) is located in the Transmission housing Drivers side behind the Dipstick Oil tube under the Distributor (hard to see!), you must remove the tube in order to access the sensor or replace it. It is a Cylindrical sensor with a tab on it for screwing it to the transmission, screw holding it is a 10mm.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the water pump on a 1994 Chrysler LeBaron 3.0L V6?
the water pump is locate in back of the motor bracket on the left side of the engine it take about 4 hours to remove it
How do you replace the fuse for the window washer on a 2007 chrysler van?
Locate fuse, pull old out, push new in.
How do you replace a battery on a Chrysler Concorde?
If what is mean is how do you locate the batter to replace it in certain models of the Chrysler Concorde such as the 2003 model.... the answer is to remove the driver side tire and fender. The batter is located in the fender skirt. Tracy Gibson of Virginia
Where do you locate the battery on a 1995 Chrysler cirrus?
To get to the battery take the driver's front wheel off.remove the 1/4 in.bolts from the inner fender liner the battery is located inside the access panel there.You need a 1/2 in. socket to loosen the hold down remove the heater wrapping and replace the battery and heater
How do you locate a 1992 Chrysler Le Baron starter?
Four cylinder, rear of engine below exhaust manifold. V6, front of engine behind motor mount.
Where do you locate the starter relay on a 1994 chrysler intrepid?
trying to replace the starter on a 1995 3.3 dodge intrepid! what problems if any can i anticipate?
How do you locate it on a 2005 Chrysler sebring touring?
Need to know what it is you want to locate.
How do you locate the coolant temperature sensor on a 2006 Chrysler Town and Country?
It is just below and behind on the area where the upper radiator hose attaches to the engine.
How do you change the alternator on a 1993 Chrysler Dynasty 3.3 engine?
locate the alternator take off the belt put new one on then the belt and your done
How to locate and replace crankshaft sensor on 1996 Oldsmobile Achieva 2.4 liter engine?
did u ever figure it out?
How do you replace thermostat on 98 Cadillac?
To replace the thermostat on a 1998 Cadillac, locate the area you will be working in. The thermostat is located at the rear of the engine on the drivers side. Then locate the upper hose. Remove the upper hose from the housing and disconnect the unit. You can then safely replace the thermostat piece.
How do you replace the thermostat on a Chrysler Pacifica?
To replace the thermostat on a Chrysler Pacifica, first locate the thermostat housing just behind the alternator. Remove the two bolts holding this on, then remove the old thermostat. Replace with a new thermostat and thermostat gasket. The put the bolts back in and tighten down. Make sure to check the antifreeze levels after this project.
