what do you reset the cehck engine light patriot manual transmission 2008?
thanks for you support.
turn ignition switch to run do not start press gas pedal to floor three times within five seconds change oil light will flash if you did it rght turn off then start engine then you are done
Turn the key to run position Depress the accelerator pedal to the floor 3times in 5 seconds. The light should flash and the go out. Turn the key off and the start the engine.
turn your key on leave 4 30 min should reset then change your crt fuse i just had da same proplem
If your vehicle happens to be a Chevrolet or GMC, turn the ignition to the on position and push the gas pedal to the floor three times within 5 seconds, the oil change light should flash five times and you're done.
If you mean theft system activated, it can only be reset through computer by an auto locksmith or dealer. If light flashes when key is on, theft was detected. If light is not on and you have no fuel at schrader valve on rail- you can try inertia switch for fuel.
To reset the light, turn your ignition to on, then press the gas pedal 3 times, then start the car. To reset the light, turn your ignition to on, then press the gas pedal 4 times then you will hear a beep, then start the car.
To reset the oil change light on a Ford f150 you start by pressing the button on the dashboard. After you press the button on dashboard, it will start to cycle through liquid level checks, such as fuel level. When it gets to the oil, press and hold the reset button.
After changing the engine oil, the system must be reset. With the ignition key to ON (engine not running), push the RESET button located in the driver's side instrument panel fuse block. The CHANGE OIL light will start to flash, press and hold the RESET button again. The reset is complete when you hear the chimes and the CHANGE OIL light goes out.
turn the ignition to "Run" or where it would be once it was started, but dont start it. quickly push the gas pedal to the floor three times. the change oil light should start flashing and it will reset.
Turn ignition on but do not start engine, depress accelerator to the floor three times within 5 seconds, oil change light should flash 5 times, oil change light is reset if you did this correctly.
turn the ignition to the run position but do not start it, pump the gas pedal 5 times til you hear a chime noise that indicates that the oil change indicator light is reset.
Start the car push the trip button until you get to engine oil and select reset and you are done.
start explorer press setup when it comes to engine check push RESET it says new oil push and hold reset it busses and it is reset until next oil change
Turn the key to "power on" (but don't START the engine!)....press the accelerator pedal 3 times within 5 seconds. The CHANGE OIL light will flash a couple of times and the reset is complete.
It is normal for it to do that when you reset it. NO worries
Turn the key to the 'on' position (do not start the truck).Wait for the change oil light to come on.Tap the gas pedal 5 times.Move key to off position, move key back to on position. The change oil light should be reset.
Turn the key to on, do not start, push the gas pedal to the floor three times, the light should flash on the dash indicating the reset. Turn the key off. You should be reset.