answersLogoWhite

0

  • Lincoln Town Car
  • Car Stalling Problems
  • Ford F-150
  • Grand Am SE

Why does a 1995 F-150 302 stall when you give it gas?

User Avatar

Wiki User

βˆ™ 2006-09-22 13:23:30

Best Answer
Copy

Most likely it is the fuel filter. This is on the frame just ahead of the gas tank on the driver's side. It takes a little tool (about $5) available from any parts store. It can be hard to take off even with the tool, and you might ruin the clips in the connector fittings. Those are also available from the parts store, at about $4. I think the fuel filter is about $12. It could also be the TFI Module located on the engine behind, and connected to, the distributor. It could also be the fuel pump.

User Avatar

Wiki User

βˆ™ 2006-09-22 13:23:30
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Can a 1989 bronco 302 engine swap into a 1995 F150 302?

sure can!


Where is the oil pressure sending unit located on a 1995 ford f150 wiith a 302 motor?

Its located in front of the oilfilter on left side of engine


Where is the egr valve located on a 1979 f150 with a 302?

The EGR valve on a 1979 F150 with a 302 is located in the center of the engine. It is close to the firewall.


What 5-speed transmission is in 1995 Ford F150?

depends on the engine. My 302 has a Mazda 5 speed almunium cast in it.


Is the firing order the same on a 302 fuel injected engine as it is on carb 302 motor?

Yes ---------------------------------- (until 1994 ) , 1995 and 1996 ( 5.0 L ) 302 v8 engines in the F150 are 1-3-7-2-6-5-4-8 In 1997 Ford started using the 4.6 L / 5.4 L V8 engines in the F150


1986 f150 302 emissom light on?

1986 f150 emisson light on is their restn set


Where can you find 1986 f150 engine diagram with 302?

Autozone


Where is the PCV valve on a 1995 F150?

PCV is usually located on the valve cover sealed by a grommet. 1995 F150 2wheel drive with a 302 engine may require removal of the intake manifold. It is connected to an oil separator to keep excessive oil form entering the cylinder combustion chamber.


Will a c6 from a 1969 f250 390 fit a 1989 302 from a f150?

No the 390 is a big block the 302 is a small block.


What is the horsepower of a 1985 F-150 with a 302 engine?

i got an 85 f150 with the 302 and i have 140 to 145 horse


Why does an F150 with a 302 stall when starting changing gears or turning corners?

My guess would be the fuel pump. I dont know how to change it, because i havent had to replace the one on my truck yet, but i would guess the fuel pump.


Will a 302 from a mustang fit a F150 with a straight 6?

yeah if u no how to do it


What is the spark plug order on the distributor cap on a f150 302?

15426378


Would a 1991 f150 dual exhaust fit on a 1992 f150 both are 302 or 5.0L?

yes they are basicly the same truck


What are the timing specs for a 1992 F150 302?

10 degrees BTDC with EFI


1992 f150 302 did it come with HO motor?

Yes. Mine did anyways.


What is the horse power rating of a 302 in a 1987 ford f150?

175 hp


What is the Spark plug gap for a 1993 f150 302 v8?

.054 inch


What is the engine size of your 1995 Ford F150 XLT truck?

you could have the : 4.9 L - 300 cubic inch - straight 6 cylinder engine 5.0 L - 302 cubic inch - V8 engine or 5.8 L - 351 cubic inch - V8 engine These are the 3 factory engine offerings on a 1995 F150


What size engine is the 4.6l in the 97 ford f150.... 302..?

It would be a 289


What is the spark plug gap for 92 f150 with 302?

.054 inch , according to fordparts.com


Does a 1986 f150 302 efi have 2 fuel filters?

some do . some don't


What is the rotor cap wire placement on a 1988 F-150 302 ci engine?

the firing order 18436572 on the 1988 f150 302


Does ford still put 302 in mustangs?

No, the 302 has not been used since 1995.


Why does my 1984 Ford F-150 302 v8 cuts out while moving?

why does my 1984 ford f150 302 v8 cut out while moving