For Security so as nobody can jump in uninvited while you are getting yourself comfortable. Try pushing the button 2 or 3 times to unlock all doors.
you hit the unlock door button twice.
To unlock the rear door ???just push the unlock button on the drivers side door on the in side and it will unlock all doors and the rear door also. then Just pill on the outside rear door handle and it will open., push the button 2 times to unlock all doors.
You push the key remote unlock button two times.....
Wedge open drivers door, insert rod push unlock button
While holding the door unlock button on your driver's door, turn the key to ON then OFF, then ON, then OFF. Release the unlock button and the doors should lock/unlock to confirm the PDM is in programming mode. Then hold the door unlock and door unlock buttons on your remote at the same time. After about 15 seconds the doors should lock and unlock to acknowledge that it's picked up the remote. Program all remaining remotes at this time. The system will take up to four remotes.
Either the key pad on the drivers' door, the remote, or use the key.
put key in ignition turn to first notch and press the remote either open or lock
To program a remote keyless entry on 1996 Chevrolet pickup, first hold down the power unlock button of the door panel. Second, turn ignition key ON, OFF, ON, OFF. Then release power unlock button on the door panel.
Here are instructions: 1. Driver's door open and unlocked, all other doors closed and locked. 2. Insert YOUR key in ignition, DO NOT TURN, remove key. 3. Using the lock/unlock button ON THE DRIVERS DOOR, slowly press lock and unlock 5 times (count the lock 5 times and unlock 5 times). 4. Shut door. 5. Open door. 6. Using the lock/unlock button ON THE DRIVERS DOOR, slowly press lock and unlock 5 times (count the lock 5 times and unlock 5 times). 7. With the door open insert your key into the ignition, turn to on position (DON'T START), wait 5 seconds. Turn off and remove key. 8. Locks should cycle once (Car will lock and then unlock once). If they don't cycle or they cycle more than once, do steps 1-7 over. 9. Now using the remote, push lock button, hold for one second, release. The locks should cycle once. If not, start over and go slower. 10. Close the door. Open the door. Press the lock button on the remote. The locks should cycle. Close the door. Press the lock button on the remote, the doors should lock. Press again and the doors should unlock. Congratulations - You are done!
To program the keyless entry remote on a Chevy Malibu, close all doors and put the key in the ignition. Hold down the power unlock button on the door while turning your key to on and off twice. Then release the power unlock button on the door.
need to be inside vehicle with key in ignition, then turn key all the way to right before start 2 times while holding down unlock button at same time with door shut. then let go of unlock button. then hold both bottons on remote down tell you hear door lock and unlock if you have more then 1 remote when first remote is done do 2nd remote aright after 1st is done holding it the same with both buttons down tell you hear door lock and unlock, its now done.
On the driver's door, push and hold the DOOR UNLOCK button until you hear the trunk lid release.