Check your Transmission Fluid level. Pull into a gas station or someplace very flat and put the car in park, and with the engine running pull the transmission dipstick, wipe it clean, insert it into the tube and pull again. The level should be on the dipstick in the band between L and H. You are probably low on fluid, you fill the transmission through the dipstick tube so make sure you get a funnel that will go into the tube from your parts store and DO NOT OVERFILL THE TRANSMISSION as this will cause seal damage and leakage.
i have a 92 s-10 blazer and it has no reverse Andy ideas?. it will go in to drive and shift in to all the gears..but will no go into reverse? can u help me
check the transaxle range switch and positioning....the holes should line up in neutral
Odds are the clutch is in need of a adjustment or replacement.
2006 ion shifts hard
it could be the shift linkage being that both gears over there wont work
yes it has reverse and both high and low range gears . i can get it to run in both forward and reverse but only in low range . when i shift IT into high range it is still running in low range .
car will jerk forward and then go in reverse
no, but dont shift the trans to first when you are going 70
In the car there's a small hole by the shift gears, take cover off, we used a metal nail file To press down, this now lets you shift gears.
The gears in your transmission may be sticking or worn out. This would cause your transmission to not be able to shift.
You press the clutch, and shift gears. There are great instructional videos on youtube.
You need a new transmision, your gears are shot.